Replacing Hydraulic Filter And Screens - Husqvarna PT26D Workshop Manual

Filling up hydraulic oil
Filling hydraulic oil Fill to approx. 60 mm
(2,1/4") below the strainer's upper edge with
hydraulic oil.
IMPORTANT INFORMATION
Used hydraulic oil is a health hazard and
must not be disposed of in the ground or in
nature.
Avoid skin contact; wash with soap and
water in case of spills.
Emptying of the hydraulic tank
Drained oil must not be refilled, but should be
treated as waste oil.
1. Place a container that holds a least
10 litres under the drain plug (43).
2. Empty the hydraulic tank through the
drainage screw underneath the tank.
Replacing hydraulic filter and
screens
IMPORTANT INFORMATION
Hydraulic filter and screens, replacement
Filler screen (45)
1. Filling hydraulic oil
2. Clean the top of the tank as set out in the
general instructions.
3. Remove the nuts (48) and lift up the filler
strainer.
4. Assemble in reverse order.
Strainer (39)
1. Filling hydraulic oil
2. Clean the top of the tank as set out in the
general instructions.
3. Release the hydraulic line from the
suction line connection on (35)
4. Remove the nuts (40) and lift up the
suction line complete (35).
5. Remove the suction strainer (39) from the pipe. Wash with white spirit and blow clean with
compressed air inside and out.
6. Assemble in reverse order. Tighten the nuts (40) moderately so the gaskets are not damage. Use a
new gasket (36).
110
English-
REPAIR INSTRUCTIONS
Drain plug hydraulic tank
Hydraulic tank
8043-117
8043-122