Cutting Unit With Suspension - Husqvarna PT26D Workshop Manual

Cutting unit with suspension

Cutting unit suspension, see figure on page 89.
WARNING!
Prevent the engine from starting
when working on moving parts.
Attaching and removing the cutting unit
WARNING!
Exercise caution.
Risk of crush injuries
Wear protective gloves
See "Side shifting the cutting unit". The
method also applies to Combi 132.
Side shifting the cutting unit
Cutting unit, Combi 155, can be side shifted
8 cm to the left or be centrally positioned on
the machine.
1. Stop the engine. Switch off the weight
transfer switch.
.
WARNING!
Never leave the propeller shaft on
the machine with one end detached.
If the engine starts, damage might
occur.
2. Remove the propeller shaft completely.
Pull the ring to release the quick connec-
tor and to be able to pull the propeller
shaft from the shaft journal.
3. Start the engine and raise the cutting
unit to the transport position.
4. Stop the engine.
5. Remove the pins on both sides.
6. Lower the cutting unit to the mowing
position.
When the engine has stopped: Ignition
switch in the ON position and the lever in
the lowered position within 3 seconds,
otherwise turn the ignition switch again.
7. Remove the pins from the shafts and
remove the shafts from the link joints.
The cutting unit has now been removed
from the machine.
REPAIR INSTRUCTIONS
Remove the propeller shaft
Remove the pins
Release the link joints
8009-762
8043-050
8009-776
87
English-