Replacing the switch for driver's seat
1.
Pull apart the connector under the
driver's seat and release the shock
absorber from the chassis.
2.
Remove the driver's seat.
3.
Remove the seat cushion from the
underframe.
4.
Remove the switch from the seat
cushion.
5.
Remove the switch from the cable. The
connector is locked by a plastic catch.
6.
Assemble in reverse order.
Sensors
The function of the sensor can be tested with
the LED, which is integrated in the sensor.
IMPORTANT INFORMATION
The sensors only permit a 200 mA load.
Do not use a test lamp for testing.
•
Hydrostatic control (drive pedals)
•
Parking brake, see page 101
•
Lifting arm
•
Differential lock pedal
Sensors are not sold separately. Replace the
cable harness with the four sensors when a
fault has been established.
Set the distance 2-3 mm between the sensor
and its target surface. Tightening torque
30 Nm.
IMPORTANT INFORMATION
The sensor has a thin wall with a fine thread
and the thread strip if tightened too tight.
102
English-
REPAIR INSTRUCTIONS
Driver's seat switch
LED in sensor drive pedals
Sensor lifting arm
Sensor diff lock pedal
8043-111
8043-171
8043-137
8043-175