Husqvarna PT26D Workshop Manual page 24

DELIVERY AND DEALER SERVICE
4. Checking oil levels
See instructions under "Repair instructions \
Lubrication system and Hydraulic system".
5. Check the air pressure in the tyres
Checking the Tyre Pressure
The tyre pressure must be 100 kPa / 1.0 bar /
14.5PSI for the front and rear wheels.
The air pressure in the cutting unit's pivot wheels
must be 150 kPa / 1.5 bar / 21.8 PSI.
6. Connecting the battery
IMPORTANT INFORMATION
Hold the bolts so that the poles are
not put under strain.
The machine is equipped with a sealed "mainte-
nance-free" battery. The battery has an inspection
hole that displays different colours:
• Green = OK.
• White = Charge the battery.
• Red = Replace the battery.
7. Filling fuel, starting the engine for the
first time
Fill a sufficient/agreed amount of diesel fuel. Bleed
the fuel system. See instructions under "Repair
instructions \ Fuel and intake system".
8. Checking neutral
Check that the drive pedals spring back to neutral
position when they are unactuated. Check with
LEDs on the sensor by the pump's operating lever.
9. Test Running
Listen for abnormal noises and check that all func-
tions works as intended. Run the engine until
operating temperature has been reached.
• Driving forwards.
• Reversing.
• Engaging the blades.
• Safety switch in the seat.
• Inductive sensor for hydrostat pedals.
• Inductive sensor for parking brake.
10.Check the engine speed
See instructions under "Repair instructions \
Checking and adjusting the throttle control".
Tachometer is described under "Special Tools".
The speeds are stated in chapter Specifica-
tions\"Engine" on page 13.
23
English-