Husqvarna PT26D Workshop Manual page 69

Replacing the engine's oil filter
WARNING!
Risk of spray and burn injuries. The
engine's oil filter may be very hot
immediately after stopping. Allow
the engine to cool somewhat first.
IMPORTANT INFORMATION
Replaced filters must be deposited with
assigned places for correct disposal. Avoid
skin contact; wash with soap and water in
case of spills.
1. Remove the oil filter. If necessary, use a
filter remover.
2. Clean the oil filter's mounting.
3. Wipe new, clean engine oil onto the seal
for the new filter.
4. Mount the filter by hand with + 3/4 turn.
5. Run the engine warm, then check that
there are no leaks around the oil filter
seal.
6. Check the oil level in the engine, top up if
necessary. The oil filter holds 0.2 litres of
oil.
68
English-
REPAIR INSTRUCTIONS
Engine oil filter
8009-801