7.
Check that the steering stop in front of
the lower bearing is secured.
8.
Assemble in reverse order. Lubricate the
bearing seatings and studs with corro-
sion inhibiting grease or copper-based
lubricant. Tightening torque according to
the table.
Replacing the parking brake pedal
Parking brake model year 2007- 2008
1.
Remove the floor plate.
2.
Remove the screw (81), nut (82),
spacer (80) and washer (83).
3.
Remove the screw (48) and release the
cable lever from the pedal.
4.
Remove the pedal downwards.
5.
Assemble in reverse order. Lubricate
with corrosion inhibiting grease. Tighten-
ing torque according to the table.
Replacing the parking brake lock
Model year 2007 - 2008
1.
Remove the floor plate.
2.
Remove the plastic panel covering the
circuit board.
3.
Remove the two screws (55) holding the
entire lock.
4.
Disconnect the cable from the lock by
angling it.
5.
Remove the entire lock.
6.
If necessary, take apart the lock by
removing the screw (43).
7.
Assemble in reverse order.
Caution: Different screws for the plastic
panel, threaded screws on top and self-
tapping screws underneath.
78
English-
REPAIR INSTRUCTIONS
8043-198, -199