Husqvarna PT26D Workshop Manual page 63

11. Remove the engine frame with the
hydraulic tank, the fuel filter and battery
shelf fitted.
12. Remove the driver's seat.
13. Remove the plate over the hydraulic
pump's drive axle.
14. Make sure that the engine cannot start
and remove the hydraulic pump's drive
axle.
15. Release the spring tension on the belt
tensioner for the power take-off belts.
16. Pry off the power take-off belts from the
crankshaft belt pulley.
17. Release the electrical cable to the sole-
noid clutch in the connector and cut off
the cable tie.
18. Loosen the lower hydraulic hose from
the working hydraulic pump.
19. Remove the upper and lower radiator
hoses.
20. Remove the muffler.
21. Remove the cooling fan to prevent it
from being damaged. See "Replacing
the cooling fan" on page 64"
62
English-
REPAIR INSTRUCTIONS
The hydraulic pump's drive axle
Release the spring tension
Dismantling the cooling fan
8043-164
8009-887
8043-143