Husqvarna PT26D Workshop Manual page 64

22. Remove the bracket screws for the cable
harness on the front of the engine.
23. Separate the fuel return line in the
connector.
24. Release the electrical cables (two) from
the starter. Cut the cable tie.
25. Release the cables to the engine tem-
perature sensor and the temperature
sensor on the thermostat housing.
26. Release the electrical cables from the
alternator.
27. Release the cable harness from the
muffler bracket.
28. Release the throttle control cable from
the injection pump's regulator arm and
the bracket.
29. Release the electrical cable from the oil
pressure sensor and the cable clamp in
the bracket behind the battery.
30. Release the electrical cable from the
front glow plug.
31. Separate the electric cable to the injec-
tion pump in the connector by the feed
pump.
32. Release the earth connection cables
from the connection point under the oil
filter.
33. Remove the large screws in the engine
mounting pads.
34. Connect the lifting device to the lifting
eyes on both sides of the valve cover.
Lift slightly, pull the engine straight back
and lift it off.
35. Clean the engine bed.
36. When replacing the engine, move requi-
site components to the new engine.
37. Check the radiator hoses. Replace them
if they are hard or have cracks.
38. Lift the engine into position. Watch the
underneath of the radiator. Guide the
solenoid clutch so that the lower cut-out
fits into its counterhold on the left-hand
side.
39. Fit the screws in the engine mounting
pads.
40. Remove the lifting device.
41. Assemble all parts in reverse order. The
screws for the rear mounting of the
hydraulic pump's drive axle are locked
with dry locks and may only be fitted
three times.
REPAIR INSTRUCTIONS
Electrical cabling right-hand side
Throttle control cable
Earth connection cables
Solenoid clutch lower cut-outs
8043-145
8009-813
8043-147
8043-212
63
English-