Husqvarna PT26D Workshop Manual page 75

Adjusting the steering rod
The steering rod is adjusted so that the
hydraulic pump reaches its stop position for
forward driving at the same time as the for-
ward pedal reaches its stop position. This
provides maximum speed for forward driving.
Before the steering rod is adjusted, the
pump's neutral position must be correctly set,
see above.
1. Loosen the lock nuts, one of which is
left-hand threaded, on the steering
rod (3).
2. Extend (turn) the rod (3) so that the
pump goes to the end position before the
forward pedal is completely pressed
down.
3. Press down the forward pedal completely
and turn the rod (3) until the forward pedal
reaches its limit stop on the bottom of the
pedal bracket, at the same time as the
pump is set to its end position.
4. Tighten the lock nuts for the rod.
74
English-
REPAIR INSTRUCTIONS
Forward pedal limit stop
8043-213