Replacing The Air Filter - Husqvarna iZ Series Operator's Manual

Replacing the Air Filter

Standard air filter
If the engine seems weak or runs unevenly,
the air filter may be clogged. If run with a dirty
air filter, the spark plugs can become fouled,
distupting operation.
For this reason, it is important to replace the air
filter regularly (see the heading Maintenance
Schedule for the proper service interval).
Cleaning/replacing the air filter is carried out
as follows:
WARNING!
The engine and the exhaust
system become very hot
during operation.
Risk for burns if touched.
Allow engine and exhaust
sytem to cool at least two (2)
minutes.
1. Remove the plastic fastener on the top of
the air filter cowling and remove the air
filter cowling.
2. Remove the foam rubber pre-filter and
clean using a mild detergent.
Squeeze it dry with a clean cloth.
3. Remove the wing nuts for the air filter
and remove the paper filter. Tap the
paper filter against a fixed surface to
remove dust. If the paper filter is still
dirty, it must be replaced.
IMPORTANT INFORMATION
Do not used compressed air to clean the
air filter.
Do not wash the paper filter.
Do not oil the paper filter.
4. Refit the air filter as follows:
Check that the seal on the bottom of the
paper filter is whole.
Mount the paper filter in the air filter
housing and tighten the wing nuts.
5. Refit the pre-filter on the paper filter.
6. Replace the cowling over the air filter
housing. Do not over tighten the plastic
fastener.
42
English-
MAINTENANCE
Remove the air filter cowling
Remove the pre-filter
Remove the paper filter
Remove dust
8011-768
8011-557
8011-558
8009-181