Husqvarna PT26D Workshop Manual page 89

8. Remove the screws for the bearing
brackets.
9. Remove the adjustment screw for tilt
angle from its mounting. TIP! Measure
where the lock nut is located on the
adjustment screw.
10. Remove the damper from the unit cover.
11. Screw in the adjustment screw for tilt
angle into the new attachment a few
turns.
12. Fit the bearing brackets and dampers in
new positions, see figure. L=left position,
C=centred. The right-hand bearing
bracket must be installed in the mounting
in the cover to prevent movement
against the underneath of the unit
mounting's arm.
13. Continue to screw in the adjustment
screw for tilt angle.
Assembling the cutting unit:
14. Install the shaft for the link joint and its
pins on both sides.
15. Install the pins on both sides
16. Stop the engine.
17. Install the pins on both sides.
18. Lower the cutting unit to the mowing
position.
When the engine has stopped: Ignition
switch in the ON position and the lever in
the lowered position within 3 seconds,
otherwise turn the ignition switch again.
19. Fit the propeller shaft.
20. Check and adjust the cutting unit tilt
angle. See "Tilt angle" on page 91.
88
English-
REPAIR INSTRUCTIONS
Bearing brackets
Adjustment screw tilt angle
Install the pins on both sides.
8043-172
8009-783
8043-050