Husqvarna PT26D Workshop Manual page 90

Replacing the lifting arms and bushings in the lifting system
Lift system
1. Remove the cutting unit, see "Side shift-
ing the cutting unit" on page 87.
2. Remove the floor plate.
3. Remove the front wheels.
4. Remove a circlip (15), knock out the
axle (14) and release the lifting cylinder
from the member.
WARNING!
Warning heavy parts are released.
5. Remove the nuts (11) and knock out the
lifting bolts (10). Model year 2008 has
two plastic washers as axial bearings.
6. Replace the bushings (6) in the arms and
the flange bushings (2) in the member.
7. Before assembling lubricate with molyb-
denum disulphide grease.
8. Caution: Risk for incorrect assembly, the
lifting arms (4) and (5) are turned so that
the brackets for the pins (9) point
upwards/outwards. Lift up the
member (1) with the lifting arms (4)
and (5) and fit the lifting bolts (10).
9. Assemble the nuts (11), tightening
torque according to the table.
10. Assemble remaining parts in the reverse order.
REPAIR INSTRUCTIONS
8043-139
89
English-