Pc Monitoring And Recording With Beatscope® Easy - FINAPRES Finometer Model-2 User Manual

Finometer Model-2
following will be dis
Physiocal
See paragraph 4.2.1 for an explanation of the format of the software
version.
T he display will be frozen until the next option in the menu is chosen or
until the menu is left.
W hen the START/STOP key is pressed at any time during the software
version display option, the system will go back into Ready mode
the configuration is saved.
When the MARKER key is pressed, the "Configuration option menu" w
show the first configuration item again, being the steady pressure
c alibration check.
5.5 PC monitoring and recording with BeatScope® Easy
It is possible to monitor and record the pressure waveform and tre
of the beat-to-beat derived parameters in real-time, when Finometer®
Model-2 is connected to a PC
to seri al converter to connect to the device's serial port, e.g. the FTDI
US232-R-100 cable. Install the correct driver to connect to COM1
COM2. See also: Installation Guide USB/RS232 converter.
The BeatScope® Easy
capabilit y in addition to control the most important functions of the
Finometer® Model-2 device from PC.
To monitor and record the pressure
real-time:
1. Connect a serial cable
indicated with the 'RS-232' label - to an unused serial port on a PC.
2. Run BeatScope® Easy.
control key functions ho
played:
S ystolic Diastolic Mean Rate (bpm)
Software version
v02.10 build 004
through the serial line or through a USB
software provides this monitoring and recording
waveform and beat-to-beat data in
from the main unit serial port connector -
Finometer® Model-2
w to enter this mode) the
Height
59
User's Guide
and
ill
nd
or