Configuration Option Menu; Steady Pressure Calibration Check - FINAPRES Finometer Model-2 User Manual

Figure 5.3 Calibration signal specification
Other c alibration options can be found in the configuration option menu
see 5.4.
Note: In ready
the applied signal of the ECG input at the front of Finometer®
Model-2.
5.4

Configuration option menu

T he "Configuration Option Menu" can
and
MARKER PHYSIOCAL
mode. The first available procedure is the steady pressure check.
Whe n the
MARKER
procedure will show the next option, being the "Pressure waveform
calibration output". Hereafter the "Beeper", "Serial protocol" and finally
the "Software version" options can b
key is pressed again, the circul
MARKER
w ill st art again with the steady pressure check.
W hen the
/
START STOP
s aved and the system goes back into Ready mode. Saved means that
t he configuration parameters for beeper and serial protocol are stored
o the internal storage as defaults, remaining valid when the device is n
s witched on again after power off.
5.4

.1 Steady pressure calibration check

When the steady pressure check is started (see Table 4.1 Finometer®
Model-2 control key functions, how to enter this mode) the following
will be displayed:
Physiocal
"G" stands for generated pressure, "M" stands for measured pressure.
"NNN" can be any numerical value between 0 and 250 in units of
1 and 5.4.2.
mode, output ch annel 3 of the I/O box will generate
key simultaneously while the system is in ready
key is press ed, the "Configuration Option Menu"
key is pressed at any time, the chosen settings ar
Systolic Diastolic Mean Rate (bpm)
STEADY PRESSURE
G:NNN M:NNN mmHg
Finometer® Model-2
be activated by pressing the
e chosen, respectively. When the
ar "Configuration Option Menu"
Height
55
User's Guide
e