Beeper Configuration; Serial Protocol - FINAPRES Finometer Model-2 User Manual

When the
/
START STOP
waveform calibration, the system will go back into Ready mode and the
configuration is saved.
When the MARKER key is pressed, the configuration option menu will
show the next configuration item, being the beeper configuration.
5.

4.3 Beeper configuration

When the beeper configuration is started (see Table 4.1,
Finometer Model-2 control key functions, how to enter this mode)
following w ill be displayed:
Physiocal
Where "XXX" can be: "on" or "off".
Default the beeper is on. Each time
beeper toggles between on or off. Also the display will change to the
actual setting.
When the START/STOP key is pressed at any time during the beeper
configuration, the system will go back into Ready
configuration is saved.
When the MARKER key is pressed, the "Configuration option menu" will
show the next configuration
c onfigurati on.
5.4.4 Seria l protocol
W hen the serial protocol configuration is started (see Table 4.1,
Finometer Model-2 control key functions how to enter this mode) the
following will be displayed:
key is pressed at any time during the pressure
Systolic Diastolic Mean Rate (bpm)
BEEPER ON/OFF
Beeper: XXX
PHYSIOCAL
item, being the serial protocol
Finometer® Model-2
Height
or
HEIGHT
mode and the
57
User's Guide
the
is pressed, the