Finometer® Model-2 Modes; Startup Mode - FINAPRES Finometer Model-2 User Manual

42 Finometer® Model-2
4.2 Finometer® Model-2 modes
Finometer® Model-2 can be in one of the following modes: Startup
(boot) mode, Connect Frontend mode, Ready mode, Run mode, or
Error mode. The information displayed on the LCD display and the
function of the keys depend on the mode Finometer® Model-2 is in.
When Finometer® Model-2 is powered, with the Frontend Unit
connected, the device will startup and enter into Ready mode. In
Ready mode Finometer® Model-2 is ready to start a finger blood
pressure measurement. Finometer® Model-2 is in Connect Frontend
mode when the Frontend Unit is not yet connected to Finometer®
Model-2.
If a measurement is started Finometer® Model-2 switches to Run
mode. This mode is continued until the measurement is stopped, either
via the keypad STOP, or via a remote PC STOP, or when an error
condition is detected. If an error is detected Finometer® Model-2
switches to Error mode. Finometer® Model-2 will stop the
measurement and alert the user by 3 beeps (if the buzzer is on, see
5.4.3) and a message on the LCD related to the error condition.
The following sections help you understanding the information
displayed in the different modes.

4.2.1 Startup mode

When the Finometer® Model-2 is powered, it will start the internal
program after performing several initializations and hardware function
checks. During startup the LCD display will show the following
information:
User's Guide
Systolic Diastolic Mean
FINOMETER M2
................
Physiocal
Rate (bpm)
Height