Software Version - FINAPRES Finometer Model-2 User Manual

58 Finometer® Model-2
Physiocal
Where "PPPPPP" can be : FMS or OHMEDA
By default the FMS protocol is selected. Each time
pressed, the protocol toggles be
When a protocol is selected and a measurement is started the serial
p ort will use the selected protocol.
Note : BeatScope® Easy uses the FMS protocol.
T he pressure recon
protocol. T he follow
is selected automa
configuratio n men and when the setting
system boot.
Serial protocol
FMS
OHMEDA
When the system is running and the serial protocol is changed fro
OHMEDA back to FMS, t
fi nger level indicated by FIN.
When the START/STOP key is pressed at any time during th
protocol config uration, the system will go back into ready mode and the
configuration is saved.
When the MARKER key is pressed, the configuration menu will show the
next configuration item, being the software version display option.
5.

4.5 Software version

When the software version display option is started (see Table 4.1,
User's Guide
Systolic Diastolic Mean Rate (bpm)
SERIAL PROTOCOL
Prot ocol: PPPPPP
tween FMS or OHMEDA.
struction level depends on the chosen serial
ing table shows which p
tically when a speci
u
he pressure reconstruction level will stay at the
Height (mmHg)
PHYSIOCAL
ressure reconstruction level
fic serial protocol is chosen in the
is loaded from disk during
Pressure reconstruction level
after system boot
BRA
FIN
or is
HEIGHT
m
e serial