Definition Of Output Signals - FINAPRES Finometer Model-2 User Manual

5.2.1

Definition of output signals

T he following outputs are available by default:
Output Signal
Nr.
1 finger
2 reBAP
3 ECG input at
the front
4 Plethysmogram
See Chapter 9 for further specifications, calibration and offset.
Note1: With BeatScope® Easy v02.10build004 it is possible to select
different signals for these 4 analog outputs. For each channel a
choice can be made from the following sig
Finger pressure; Height; Calibration (Square Wave), Marker*;
Finap (Filtered Finger Pressure); reBAP (reconstructed brach
artery pressure); SYS (Systolic pressure), DIA (Diastolic
pressure); MAP (Mean arterial pressure) and HR (H
See BeatScope® Easy manual for further information.
When the
*)
keypad, the
2V as long as the key is pressed. When a marker is
Beat-Scope® Easy, the
1V.
Finometer® Model-2
Description
Finometer® Model-2 Finger waveform is
the raw continuous finger pressure
signal.
Finometer® Model-2 reBAP waveform is
the reconstructed brachial artery
pressure signal.
Finometer® Model-2 ECG is the analog
ECG signal which is available when the
optional ECG module (section 3.5) is
connected to the ECG input at the front
(see Figure 1.1), or any other external
signal applied to this input.
Representing the volume pulsations of
the finger arteries as seen by the finger
cuff plethysmograph.
key is pressed on the Finometer® Mod
MARKER
output channel will generate a voltage of
MARKER
output will generate a voltage of
MARKER
User's Guide
nals / parameters:
ial
eart Rate).
el-2
set with
53