50 Finometer® Model-2
Troubleshooting
•
When the offset of the Height Correction Unit tra
than 15 mmHg, the lower line during height-nulling reads e.g.:
This message is accompanied by
buzzer is on, see 5.4.3). Check th
Correction
Unit are in
and 4 above.
The height value displayed here is the offset of the Height
Correction Unit transducer. If the error persists, contact Finapres
Medical Systems B.V. and report the offset.
•
When the Height Correction Unit is not co
the nulling procedure, the display will change to:
When this message is displayed, connect the connector of the
Height Correction Unit to the Frontend Unit.
Note 1: If the Height Correction Unit has been nulled, the measured
fing
er blood pressure and derived beat-to-beat data will be corrected
for hydrostatic hei
Correction Unit will result
hydrostatic height.
Then, the lower l
height value, e.g.:
User's Guide
Systolic Diastolic Mean
Height Null:STOP
ERROR! HEIGHT+21
Physiocal
deed at the same level. If not repeat steps 3
Systolic Diastolic Mean
Height Null:STOP
NOT CONNECTED
Physiocal
ght differences. Disconnection of the Hei
in measurements not correct
ine in t e display shows the stri g 'NC' ins
h
nsducer is more
Rate (bpm)
Height
three beeps of the buzzer (if the
at both ends of the Height
nnected while performing
Rate (bpm)
Height
ed for
n
ght
tead of the