Emerson Rosemount Analytical X-STREAM Enhanced Series Short Form Manual page 82

X-STREAM XE
Ch1
Measurement 1of2
Ranges..
Damping..
Linearization..
Cross Interference..
Average..
Delay..

Ch1
Measurement 2of2

Cut-off:
Pressure Compensation ..
Ch1
Pressure compensation
Manual Pressure:
Pressure
Pressure Status
3-18
3.5.7 Checking the Settings
None
1013 hPa
1013 hPa
Good
If "AfterCalCheck" is enabled (On), the cali-
bration procedure adds an additional phase
where it measures and stores the concentra-
tion value shortly after the calibration.
Press several times to return to SETUP
left
and open MEASUREMENT.
Signal damping (set in DAMPING) allows
smoothing the output signal, but also affects
the response time of outputs and display:
• The factory setting is 0 seconds.
• The maximum possible t
the size of the internal sampling buffer and
the sampling rates of the installed measur-
ing principles/sensors.
• Multi-channel units: the value for each
channel must be entered separately.
The last line of the second page (Pressure
Compensation) enables the user
• to enter the current ambient pressure
manually, if no pressure sensor is in-
stalled,
or
• to view the current pressure, if a sensor
is installed (
If no pressure sensor is installed, enter the
current ambient pressure here and adjust
it, when significant changes take place: this
improves the accuracy of the instrument.
Emerson Process Management GmbH & Co. OHG
Short Form Manual
HASXEE-SFM-HS
05/2017
time is limited by
90
INSTALLED OPTIONS).