Harvia sentiotec wave.com4 Instructions For Installation And Use Manual page 70

Instructions for use for the user
8. Several operating units on the bus
The address can be changed as follows:
Unplug the bus/supply cable of the operating unit.
Press and hold the
meanwhile plug the data cable into the relevant port on component WC4-B-L.
You can now see the address assigned to this operating unit flashing. Change the
address with the
5
units are used. Confirm your selection with the
When the aforementioned settings have ended, the Wave.com4 sauna control
unit must be disconnected from the mains and reinitialised (address recognition
occurs when the Wave.com4 sauna control unit is started up).
TIP!
You can in practice connect max. 2 operating units and in theory 4 ope-
rating units to the bus (Port RJ10 4/4).
TIP!
If you use several operating units, you must assign each operating unit a
bus address. Address 0 is the standard value.Each address can be used
only once or may not be assigned to multiple operating units.
and keys on the unplugged operating unit and and
5 6
and keys (address 0-3 possible) when several operating
6
button.
7
p. 28/42