Safety Information For The Installer - Harvia sentiotec wave.com4 Instructions For Installation And Use Manual

Instructions for installation and use

2.2. Safety information for the installer

● Installation may only be performed by a qualified electrician or
similarly qualified person.
● Work on the sauna control unit may only be performed when the
power has been disconnected.
● An all-pole disconnecting device with full cut-off compliant with
overvoltage category III must be fitted on-site.
● The power unit of the wave.com4 (WC4-BL) must be installed
outside the sauna cabin – preferably on the cabin roof.
● The operating unit may be mounted inside and outside the sauna,
but the requirements of the included installation and operating
instructions must be followed.
● The heater sensor must be attached in a way that ensures it is
not affected by inflow of air.
● The heater supply cable must have a minimum cross-section of
2.5 mm 2 and be temperature resistant up to 150 °C.
● Observe all regulations applicable in the installation location.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 6/42