Table of Contents
Advertisement
Available languages
Available languages
Instructions for use for the user
4.8. Electronic hour glass
Change to the symbol
and set your desired interval with the
you via an acoustic signal (buzzer is integrated into the power unit), that your
desired interval (run time) has elapsed. The acoustic signal can be switched off
(see Point „Operating mode" of these operating instructions).
4.9. Dimming the cabin light
Change to the symbol
brightness with the keys
•
Switch the cabin light off by briefly pressing the key
•
Switch the cabin light on by briefly pressing the key
•
Dim the cabin light (power) by pressing and holding the keys
4.10. Setting humidity (optional: WC4-H-PCB)
Change to the symbol (light brightness)
brightness with the keys
After approx. 3 secs. (without pressing the keys again) the control unit automa-
tically reverts to the previous display (actual temperature).
Humidity operation:
Humidity operation is dependent on sauna temperature. This is why humidity
operation works up to a sauna temperature of 70°C. Observe the standard curve
(see Figure 9 of these operating instructions).
CAUTION!
The water evaporator must be fitted with a safety switch in the event of
water deficiency.
(time interval, electronic hour glass) with the key
a
5
(light brightness) with the key
2
and
.
5
6
and
5
6
and
keys. The hourglass can notify
6
7
with the
key and set the desired
3
7
p. 22/42
7
and set the desired
.
5
.
6
or
6
5
.
Advertisement
Chapters
Table of Contents
