Automatic Switch-Off - Harvia sentiotec wave.com4 Instructions For Installation And Use Manual

Instructions for use for the user
The automatic function of the Wave.com4 sauna control unit is active when the
and symbols illuminate. The operating unit display now shows you the
8 a
remaining time in hours until the Wave.com4 sauna control unit starts the ope-
rating mode pre-programmed by you.

2. Automatic switch-off

Activate the main switch which disconnects the Wave.com4 sauna control unit
from the mains at all poles after use. The
The automatic switch-off can be automatically programmed by simultaneously
pressing (3 secs.) the
12) with the und
5
3. Temperature rectification
The use of components WC4-B-L, WC4-B-F1, WC4-H-PCB and WC4-H-F2 is
recommended for the Finnish sauna for exact temperature regulation!
TIP!
Using these components enables your Wave.com4 sauna control unit to
regulate according to an exact temperature value (regulation according
to the bench sensor).
TIP!
When only using the components WC4-B-L and WC4-B-F1 for the Finnish
sauna, the Wave.com4 sauna control unit only regulates according to
the heater sensor. The temperature measured above the heater deviates
from the temperature on the bench.
and keys. Now set a time interval in hours (1 to
5 4
keys. Confirm your selection with the
6
on the operating unit illuminates.
8
p. 24/42
key.
4