Safety Instructions; Warning And Symbols - PLUSOPTIX PowerRef 3 Instruction Manual

1. Safety instructions

Please read all of the instructions in this manual by all means in order to avoid any
danger to life and health, to achieve reliable measurement results and to obtain the
device in good working conditions.

1.1 Warning and Symbols

ATTENTION: This symbol is intended to advise the user of the presence of
Service or repair to be performed by qualified authorized personnel only.
There are no user serviceable parts inside the instrument. Opening this
device can expose the user to harmful invisible electrical shock.
Note: Disassembly of plusoptiX R09 device will void the warranty. Refer
Do not sterilize the plusoptiX R09 device or any of the components.
CAUTION: Use of controls or adjustments or performance of procedures
The CE mark on this device indicates that it has been tested and conforms
0123
to the provisions noted within the 2007/47/EG Medical Device Directive.
At the end of life time (electronic waste).
ESD sensitive device: Discharge human body by touching a grounded plane
or use ground strips before installation or touching the connectors.
This symbol shows that this product keeps the requirements for an
application part type B of EN 60601-1.
important operating or maintenance requirements.
all servicing to Plusoptix authorized service representatives listed in
the section Service and Maintenance (Chapter 11).
other than those specified herein may result in wrong
measurements.
Page 4 of 34