Features And Benefi Ts; Figure 1-1, Power Switch, Status Led, And Accessory Connection Ports - Magnum Energy MagnaSine Hybrid MSH3012RV Owner's Manual

Introduction
1.3 Features and Benefi ts
The MSH3012RV inverter/charger is designed to allow easy access to wiring, circuit breakers, and
controls. Its die cast baseplate with one-piece aluminum cover ensures maximum durability with
minimum weight, as well as cooler, more effi cient operation.
The bottom of the MSH3012RV is equipped with the following features (Figures 1-1 and 1-2):
Power ON/OFF Switch – a momentary pushbutton switch that alternately turns the
1
inverter on or off.
Status LED Indicator – this green LED illuminates to provide status information on
2
inverter or charger operation.
Accessories Connection Port (red label) – a RJ11 port that accepts optional pigtail
3
accessories (red-labeled).
Note: The MSH3012RV does not have the ability to be stacked.
RV-C Status LED – this yellow LED is used to determine the RV-C connection's status.
4
See Section 3.8 for additional information.
RV-C Connection Port (white label) – an electrically isolated CAN communication port
5
that allows RV-C control of the features and settings in the inverter and in any optional
network capable Magnum accessories (i.e., Auto Gen Start or Battery Monitor). See Section
2.8 for more information.
Note: If using the RV-C connector port, do not connect a remote control. The MSH3012RV
inverter will only communicate with the remote control if connected.
Network Connection Port (green label) – a RJ11 port that allows Magnum network
6
accessories (blue or green labeled) or a remote control to be connected.
Note: If using a remote control, you can NOT use the RV-C connector port. The MSH3012RV
inverter will only communicate with the remote control if connected.
Battery Temperature Sensor Port (yellow label) – a RJ11 port that accepts the
7
remote Battery Temperature Sensor (BTS).

Figure 1-1, Power Switch, Status LED, and Accessory Connection Ports

Page 3
1 Power ON/OFF Switch
Status LED Indicator
2
(Charging/Inverting)
Accessories Connection Port
3
(red label – RJ11 connection)
4 RV-C Status LED
RV-C Connection Port
5
(white label – 4-pin connection)
Network Connection Port
6
(green label – RJ11 connection)
Battery Temperature Sensor Port
7
(yellow label – RJ11 connection)
© 2020 Sensata Technologies