Features And Benefi Ts; Figure 1-1, Power Switch, Status Led, And Accessory Connection Ports - Magnum Energy Sensata MagnaSine Owner's Manual

1.2 Features and Benefi ts
The MS-PAE Series inverter/charger is designed to allow quick access to wiring, circuit breakers
and controls, and easy viewing of the LED (Light Emitting Diode) status indicator. Its die cast
base plate with one-piece aluminum cover ensures maximum durability with minimum weight,
as well as cooler more effi cient operation. The MS-PAE Series has the following external features
(see Figures 1-1, 1-2, and 1-3):
Power ON/OFF Switch – a momentary pushbutton switch that alternately turns the
1
inverter on or off.
Charging/Inverting LED Indicator – a green LED that illuminates to provide information
2
on inverter or charger operation.
Stack/Accessories Port (red label) – a RJ45 port that connects to the ME-RTR router,
3
which is used to confi gure and synchronize multiple MS-PAE units to operate in parallel
for increased power capacity.
CAUTION: Only connect this parallel Stack port to a ME-RTR router. Although the cabling
and connectors used in this network system are the same as ethernet connectors, this
network is not an ethernet system. Attempting to connect these two different systems
may cause damage and is not covered under warranty.
Info: MS-PAE Series inverters cannot be connected in parallel without networking them
to the optional ME-RTR (AKA router).
Network Port (green label) – a RJ11 port that accepts optional network-capable
4
accessories [i.e., Auto Gen Start (AGS) or Battery Monitor (BMK)].
Remote Port (blue label) – a RJ11 port that allows optional remote control displays
5
(i.e., ME-RC, ME-ARC, or ME-RTR) to be connected.
Battery Temp Sensor Port (yellow label) – a RJ11 port that accepts the remote Battery
6
Temperature Sensor (BTS) accessory.

Figure 1-1, Power Switch, Status LED, and Accessory Connection Ports

© 2017 Sensata Technologies
1
Power ON/OFF Switch
2
Charging/Inverting LED Indicator
Stack/Accessories Port
3
(red label – RJ45 connection)
Network Port
4
(green label – RJ11 connection)
Remote Port
5
(blue label – RJ11 connection)
Battery Temp Sensor Port
6
(yellow label – RJ11 connection)
Introduction
Page 3