Inverter Warning Label; Rv-C Communication Connection Port; Figure 2-15, Warning Label; Figure 2-16, Rv-C Connections (Single Inverter With Accessories) - Magnum Energy MagnaSine Hybrid MSH3012RV Owner's Manual

Installation
2.7

Inverter Warning Label

A warning label as shown in Figure 2-15 is provided to inform all personnel that an inverter is
installed in your electrical system. Affi x this label in a clearly visible location at the electrical panel
that is being powered by the inverter. This is because it might be falsely assumed that the panel
is no longer "hot" after the AC power has been shut off, when power may actually still be available
due to the inverter automatically powering the panel.
This electrical system is equipped with an Automatic Generator
Starting (AGS) device and/or an inverter. Disconnect all AC and
DC power to the AGS and/or inverter before performing any
service to the electrical system. Failure to do so can result in
shock causing serious injury or death.
2.8

RV-C Communication Connection Port

The MSH3012RV inverter/charger has a RV-C connection port (Figure 1-1, Item 5). This connection
port is used to communicate with RV-C compliant devices that are connected to the RV-C network
bus/backbone in the RV (Figures 2-16 and 2-17). Use the information shown in Figure 2-18 to connect
the inverters 4-pin RV-C connector to the plug and cable from the RV-C network bus in the RV.
Info: Power needs to be provided to the RV-C connector from the RV-C network bus.
Note: The RV-C plug and cable are NOT supplied.
ME-BMK
Phone
splitter

Figure 2-16, RV-C Connections (Single Inverter with Accessories)

Page 29
WARNING
ELECTRICAL SHOCK HAZARD

Figure 2-15, Warning Label

Network Bus/Backbone In RV
T
RV-C
compliant
device
ME-AGS-N
PN: 62-0002 Rev B
RV-C
compliant
device
Magnum MSH3012RV
© 2020 Sensata Technologies
T