Features And Benefi Ts - Magnum Energy RD-E Series Owner's Manual

1.1 Features and Benefi ts
The RD-E Series inverter/charger is designed to allow easy access to wiring, circuit breakers, and
controls. Its die cast baseplate with one-piece aluminum cover ensures maximum durability with
minimum weight, as well as cooler more effi cient operation.
The front of the RD-E Series is equipped with the following features (see Figures 1-1 and 1-2):
Power ON/OFF Switch - a momentary pushbutton switch that alternately turns the inverter
1
On or Off.
Status LED Indicator - this green LED illuminates to provide information on the inverter
2
or charger operation.
Stack/Accessories Connection Port (red label) - a RJ11 port that accepts the optional
3
Remote Switch Adapters (RSAs) which enable remote on/off switch operation.
Info: The stacking feature is NOT available with the RD-E Series.
Network Connection Port (green label) - a RJ11 port that accepts optional network
4
capable accessories (e.g., Auto Gen Start or Battery Monitor).
Remote Connection Port (blue label) - a RJ11 port that allows the optional remote
5
controls (ME-RC50 or ME-ARC50) to be connected.
BTS Connection Port (yellow label) - RJ11 port that accepts the remote Battery
6
Temperature Sensor (BTS) accessory.
DC Equipment Ground Terminal - this connection is used to tie the exposed chassis of
7
the inverter to the DC grounding system. This terminal accepts CU/AL conductors from
#14 to #2 AWG (2.1 to 33.6 mm
AC Input/Output Connections - two 3/4" knockouts provided with cable-clamp
8
reliefs to allow and hold the AC input and output
Intake Air Vents - ventilation openings to pull in air to help keep the inverter cool for
9
peak performance.
Positive DC Terminal - provides 360 degree connection point for the positive (+) cable
10
from the battery bank; provided with a Kep or Flange nut on a 5/16-18 bolt (5/8" usable
length) to hold the battery cable to the DC terminal.
Negative DC Terminal - provides 360 degree connection point for the negative (-) cable
11
from the battery bank; provided with a Kep or Flange nut on a 5/16-18 bolt (5/8" usable
length) to hold the battery cable to the DC terminal.
12 Mounting Flange - used to secure the inverter to a shelf or wall.
© 2010 Magnum Energy, Inc.
).
2
fi eld
Introduction
wiring.
strain
Page 2