Packing - Siemens 8DJH Installation And Operating Instructions Manual

Installation
Transport unit
48/121
ATTENTION
Danger due to transport units falling down. The center of gravity of the transport units is not
always located under the fixing point.
➭ Lift the transport units slowly.
➭ There must be no persons standing in the swinging area of lifted transport units.
➭ Transport only transport units with a max. width of 2.00 m or max. height of 2.60 m.
➭ Observe the adhesive label with transport information provided on the switchgear.
- The angle between the crane chains at the lifting facility must be less than 90°.
- The distance between the transport eyes and the lifting facility must be at least half the
switchgear width.
Fig. 22: Adhesive label with transport information on the
switchgear (example)
➭ Lift or lower just slowly, as the switchgear will swing into the center of gravity when it is
lifted.
➭ While lifting, observe parts laid inside such as cable-type transformers, connecting cables.
11.2

Packing

The transport units can be packed as follows:
• On pallets, covered with PE protective foil
• In a seaworthy crate (switchgear is sealed with desiccant bags in PE foil)
• Other packings in special cases (e.g. latticed crate, cardboard cover for airfreight)
ATTENTION
Packing and consumable materials of the switchgear must be disposed of in an
environmentally compatible way or recycled.
➭ Observe local regulations for disposal and environmental protection.
Transport units consist either of individual panels or panel blocks with max. four functions,
and the switchgear accessories. The switchgear accessories are packed in the cable
compartment of the first panel or in a separate transport box, depending on the extent.
Revision 05 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DJH • 500-8067.9
① Pallet
② Bolted joint between
transport unit and pallet
③ Transport eyes
④
Clearance for fork-lift trucks
⑤ Cable compartment cover
⑥
Ready-for-service indicator
⑦ Center of gravity