Table of Contents
Advertisement
O p t i o n :
S N M P
A g e n t
PAG E 4 6
8.1
Putting the SNMP Agent into operation
Please cable all components as shown in FIG. 28. In addition to the ETI De-
coder Software you need to install the SNMP AGENT Software from your in-
stallation CD.
Then, please start the SNMP AGENT Admin Software. FIG. 29 shows the
main window of the administration software of the SNMP Agent.
Select Search → Broadcast Search
Agents in the network.
FIG. 29
Please select the desired SNMP Agent and then, click on the Configuration
menu. In the configuration dialog you can adjust the following settings
– Ethernet: all relevant network settings
– Serial: the parameters of the serial interface
– System: name and password
For the start-up, only the Ethernet settings are relevant at first. Please enter
the desired IP address, the net mask and the gateway. You will get this infor-
mation from your administrator. Under IP Mode please select Static IP and
press the OK button afterwards.
FIG. 30
1 If you already know the IP address of the SNMP Agent, you can also search via the menu item Search by IP.
2 To change settings, you need to enable the Change ... check box.
1
in the menu to search for all SNMP
SNMP AGENT ADMIN MAIN WINDOW
ETHERNET CONFIGURATION
2
:
Advertisement
Table of Contents
