Putting The System Into Operation; Mounting; Connection To The Mains Voltage; Earthing Of The System - AVT MAGIC AE1 DAB+ Hardware & Software Manual

3 P U T T I N G T H E S Y S T E M I N T O O P E R A T I O N
3.1

Mounting

With its dimensions (W  H  D) of 431 mm  44,5 mm (1 U)  250 mm the
MAGIC AE1 DAB+ system can be used either as desktop device or mounted
in 19 inch racks. Corresponding 19" mounting brackets are included in deliv-
ery.
When mounting the unit please keep in mind that the bending radius of the
cables is always greater than the minimum allowed value.
When the MAGIC AE1 DAB+ audio encoder is installed, please make sure
that there is sufficient ventilation: It is recommended to keep a spacing of ca.
3 cm from the openings. In general, the ambient temperature of the system
should be within the range of +5  C and +45  C. These thresholds are espe-
cially to observe if the system is inserted in a rack. The system works without
ventilation.
TIP
The system temperature can be indicated on the display (
(see CHAPTER A1.4, Page 89))
During operation air humidity must range between 5% and 85%.
ATTENTION Incorrect ambient temperature and humidity can cause functional defi-
ciencies.
!
Operation outside the threshold values indicated above leads to a loss of war-
ranty claim.
3.2

Connection to the mains voltage

The system can be operated with mains voltages in the range from 90 V to
253 V. The frequency can vary from 45 Hz to 65 Hz. The maximum power
consumption is 15W (typically 12W).
After plugging the mains connector and switching on the system boots within
a few seconds. In stand-by mode the MAGIC AE1 DAB+ logo is shown on the
display.
3.3

Earthing of the system

For EMC reasons an earthing via the earthing screw of the system is recom-
mended.
ATTENTION Earthing
A lacking earthing can cause functional deficiencies within the unit.
!
P u t t i n g t h e s y s t e m i n t o o p e r a t i o n
P A GE 1 9