Table of Contents
Advertisement
7.10
Display of the System Alarm Counter
Using the page System Alarm Counter all alarms of the interface unit (IFE)
will be shown. These alarm counters are corresponding to the 2-Mbit Status
LEDs (see CHAPTER 7.8).
In addition all synchronisation errors of the ISO/MPEG Audio Decoder will be
counted (ISO/MPEG Decoder not synced).
Remark
Note, that this error counter has no relation to the error counter of the Audio
subchannels (see CHAPTER 7.12).
i
The communication between the Interface unit and the ISO/MPEG Decoder is
realized via the proprietary Extension Bus of the system. If there are errors in
the communication between the units the error counter No communication
with Audio Decoder will be increased.
FIG. 25
The button
Remark
The storage of all error counters will be done in the system. If you switch off
the system all counters will be lost.
i
Closing or starting the software has no effect for the counters, only the LEDs
will be resetted.
W i n d o w s
P C
S o f t w a r e
DISPLAYING OF THE SYSTEM ALARM COUNTER
resets all error counters.
E T I
D e c o d e r
PA G E 4 1
Advertisement
Table of Contents
