Conveyor Belt Replacement And Adjustment Instruction - SaMASZ KDD 860 Operator's Manual

6.8.2.

Conveyor belt replacement and adjustment instruction

Mower KDD 860/940 with conveyors must be suspended onto tractor. Lean the mower with
use of upper connector (cylinder) maximally to the front – in order to increase the distance between
conveyor and the ground.
I. Steps to be taken when transporting in operating position (horizontal).
1. Using a marker, mark lines on millimetre measures – decal 27 (if belts worked well).
2. Loosen tightening roller mechanism – screws M10 - S
adjustment screw M12 – S
Driving roller hydraulic
engine
`
(do not adjust)
II. Steps to be taken when transporting in vertical position. Mower shall be leaned to the front
so the distance between conveyor and the ground is approx. 1 m.
1. Loosen screws M10 – S
(Fig. 32).
S
1
Operator's manual
by approx. 30 mm (Fig. 31).
2
Fig. 31.
, nuts M12 – N
1
S
2
N
Fig. 32.
Double-sided disc mowers
with central suspension
, nuts M12 – N
1
S
1
N
adjustment screws M12 – S
2
- 32 -
and loosen
2
measure
30 mm
of front tensioners
2
S
S
1
N
S
2
2