SaMASZ KDD 860 Operator's Manual page 35

2. Dismount front belt in lower part of the conveyor P (Fig. 33). Slide belt T down (Fig. 34)
Fig. 33.
3. Clean and check condition of bearings in rollers – worn ones shall be replaced.
4. Mount the new belt upwards.
5. Mount front belt P.
6. Mount front tensioners and tighten rear tensioner.
III. Steps to be taken with conveyor lifted to horizontal position.
1. Mark two lines on newly mounted belt in intervals of l = 1000 mm (Fig. 35).
2. With adjustment screws S
l = 1005 mm (lines on measures from item I. 1 may prove to be helpful).
measure
3. Measure diagonals with use of 3-meter measure using angle bars.
4. Connect the mower and especially hydraulic drive.
5. Adjust with screws S
are no bulges on the belt.
CAUTION:
Precision is recommended, so belts and their edges worked
symmetrically on rollers. Well-adjusted belt cannot be bulged in places
where v-belt is guided inside the roller channel.
Operator's manual
P
tighten the roller so the distance on belt between marked lines is
2
S
1
Fig. 35.
locking screws S each time – to be repeated until fine tuned, so there
2, 1
- 33 -
Double-sided disc mowers
with central suspension
Fig. 34.
l
S
2
about 1 m
T
S
2