FULTON VSRT Series Installation And Operation Manual page 7

Label all wires prior to disconnecting when servicing
controls. Wiring errors can cause improper and
dangerous operation.
Operating the equipment beyond its design limits can
damage the equipment and can also be dangerous.
Do not operate the equipment outside its limits.
Do not try to upgrade the equipment performance
by unapproved modifications. Unapproved
modifications can cause injury and damage.
Contact your Fulton dealer before modifying the
equipment.
Defective equipment can injure you or others. Do
not operate equipment which is defective or has
missing parts. Make sure all repairs or maintenance
procedures are completed before using the
equipment. Do not attempt repairs or any other
maintenance work you do not understand.
Never attempt to operate equipment that has failed to
pass all the safety checks.
Please read these instructions and save for reference.
! WARNING
After checking controls by manual adjustment,
always ensure they are reset to their proper settings.
Follow proper lockout/tagout procedures for the
electrical, gas and water connections.
If any "Manual Reset" limit device trips, DO NOT
reset without determining and correcting the cause.
(Manual Reset Limits may include: flame safeguard,
high or low gas pressure, high temperature limit, high
pressure limit.)
Never tamper with low water (liquid level) cutoff
sensors or circuitry.
Before commissioning the equipment, verify with
authorized personnel that gas lines have been purged.
Questions? Call (315) 298-5121, or visit us online at www.fulton.com
SAFETY & WARNINGS - 1
Check daily that the equipment area is free and clear
of any combustible materials, including flammable
vapors & liquids.
WHAT TO DO IF YOU SMELL GAS:
ƒ Do not use matches, candles, flame or other sources
of ignition to check for gas leaks.
ƒ Do not try to light the appliance.
ƒ Do not touch any electrical switch; do not use any
phone in your building.
ƒ Immediately call your gas supplier from a safe
location.
ƒ Follow the gas supplier's instructions. If you cannot
reach your gas supplier, call the fire department.
A qualified installer, service agency or the gas supplier
must perform installation and service on the fuel
delivery system.
! WARNING
Do not store or use gasoline or other flammable
vapors and liquids or corrosive materials in the vicinity
of this or any other appliances. Cements for plastic
pipe should be kept away from all sources of ignition.
Proper ventilation should be maintained to reduce the
hazard and to minimize breathing of cement vapors.
No shutoff of any kind shall be placed between
the safety relief valve and the equipment or in
the discharge pipe between such valve and the
atmosphere. Doing so can cause an accidental
explosion from overpressure.
The discharge from the safety relief valve shall be so
arranged that there will be no danger of scalding
personnel or damage to equipment. Provisions
should be made to properly drain safety relief valve
discharge piping.
Fluids under pressure may cause injury to personnel or
damage to equipment when released. Be sure to shut
off all incoming and outgoing fluid shutoff valves and
1-3
VSRT_IOM_2018-1213