Lucent Technologies PARTNER Voice Messaging Installation And Programming Manual page 23

4. Power up the system:
a. Reconnect the power cord.
b. If you have a 5-Slot carrier, move the carrier's On/Off switch to the "On" position ("—").
5. Check that the green light on the front of each module is lit:
a. If a single light is out, power down the system, reseat the module, then power up the
system.
If multiple lights are out, power down the system, reseat the leftmost module that has a
light out, then power up the system.
b. If the lights are still out, in the continental U. S., contact your Lucent Technologies
Representative or local Authorized Dealer.
6. If you have a 2-Slot carrier or a standalone configuration, you are finished with this procedure.
If you have a 5-Slot carrier, continue with Step 6A.
a. Make sure all modules are seated properly. The cover will not fit if the modules are not
seated properly.
b. To replace the cover, grasp it by its upper edges and hold it squarely over the control unit.
c. Place the cover over the modules and make sure it fits firmly in place.
d. Tighten the screw on the lower front cover.
When the PARTNER Voice Messaging PC Card is installed in the PARTNER communications system
processor module and the system is powered up, some settings are established for both PARTNER
Voice Messaging (see "System Capacities and Factory Settings" in Chapter 1) and the PARTNER ACS
system or PARTNER Endeavor system.
If you want to make changes to the initial settings for PARTNER Voice Messaging, use the instructions
in Chapter 4. If you want to make changes to the initial PARTNER ACS or PARTNER Endeavor
settings, use the instructions in Chapter 5.
Installation Instructions
Important Safety Instructions
15