Completing This Form; Programming Procedure - Lucent Technologies PARTNER Voice Messaging Installation And Programming Manual

PARTNER Voice Messaging Installation and Programming
Release 2 supports up to 4 mailboxes, which are identified as 01, 02, 03, and 04.

Completing this form

To identify your system configuration (that is, the number of mailboxes supported), place a
checkmark ( ) in the appropriate area (for Release 3.0 or later).
The R3S configuration can support up to 4 mailboxes, which is the factory setting indicated by the
and the R3L configuration can support up to 16 mailboxes (factory set at 8 mailboxes). The amount of
message recording time available for each mailbox depends on how system capacity is configured
(see "System Specifications" in Chapter 1).
To assign a mailbox to an extension other than the factory setting, write in the extension to be
used.
For PARTNER Advanced Communication System R1.1, use an extension number from 10–41.
For PARTNER ACS Release 2.0, use an extension number from 10–49.
For PARTNER Endeavor Release 1.0, use an extension number from 10–49.
For every mailbox in use, write the name of the mailbox subscriber.

Programming Procedure

To change the system configuration, dial 2 from the System Administration Menu
(Release 3.0 or later).
To assign a mailbox to an extension, dial 1 from the System Administration Menu.
Form 1: System Configuration and Mailbox Assignments
46
,