Siemens SICHARGE CC AC22-MID Operating Instructions Manual page 72

The status LED pulsating in blue indicates that current is flowing to the vehicle and the
vehicle battery is charging. The status LED lights up permanently in blue in the following
cases:
• The vehicle is not drawing power.
– The charging station pauses, for example, because of load management
– The vehicle pauses the charging
• The charging of the vehicle battery is completed.
Completing the charging
Your vehicle is being charged as long as the light pulsates in blue. Charging is complete when
the light of the status indicator is constant.
You can stop charging at any time.
Note
Option: Permanently installed charging cables
After charging, place the permanently installed charging cable in the holder provided.
Cables that are not stowed may cause the following hazards:
• You may trip over it
• Damage to the plug
• Damage to the cable
• Moisture may enter the plug
There are 3 different ways to terminate charging:
Procedure with RFID card
Proceed as follows to end the charging process with the RFID card:
1. Charging point selection: Press the pushbutton below the display and follow the
instructions.
2. Place the RFID card onto the icon for the card reader.
Once the RFID card has been identified, the validity is checked.
3. The display shows: STOP CHARGING. Charging stops.
The status indicator changes from blue to yellow.
4. The charging cable is now unlocked. Remove the charging cable.
5. Also unplug the connector from the socket of your electric vehicle. Stow away the provided
charging cable. To do this, follow the instructions in the manual for your vehicle.
SICHARGE Operating Instructions MID
Operating Instructions, 07/2020, A5E48573001-AB
Operation
6.3 Charging
71