Teldat H1 RAIL Series Installation Manual page 12

2 Installation
Note
Configuration for the terminal must be as follows:
- Speed: 9600 bps.
- Eight data bits.
- One stop bit.
- No parity bit.
- No type of flow control.
Connection to the configuration port can be carried via a DB9 Male and DB9 Female connector. If the terminal has
DB25 connectors, you will need to use an additional adapter.
Connection for configuration
Fig. 8:
2.1.6.2 Configuring through the IP terminal (LAN1..4 connectors)
The Teldat H1 RAIL router includes a default configuration that activates if the device has not been previous con-
figured.
The router's default configuration establishes the following IP access address and mask:
Note
Some devices leave the factory with a customized configuration for a specific client. This personaliza-
tion can mean that the default configuration is different from the one shown above.
This initial configuration means you can access the device's configuration console through the Telnet IP protocol. To
do this, carry out the following steps:
• Configure the Ethernet interface on the IP terminal (normally a PC) using the IP address from the following range
[192.168.1.2, 192.168.1.254] and mask 255.255.255.0. E.g. 192.168.1.2, 255.255.255.0.
• Connect the IP terminal's Ethernet interface to any of the Ethernet Switch ports on the Teldat H1 RAIL router (the
LAN1..4 connectors) through an appropriate Ethernet cable (M12 to RJ45).
• Start a Telnet session from the IP terminal to IP address 192.168.1.1 (the Teldat H1 RAIL router default address).
• The default configuration does not ask for login credentials (user/password) to access the console.
For further information on how to fully configure the device, please see the manuals provided by Teldat on the docu-
mentation CD or through the WEB page.
8
• IP Address: 192.168.1.1
• IP Mask: 255.255.255.0
Teldat S.A.
Teldat H1 RAIL