Testing The Printer; Configuration Ticket; Figure 13: Sample Test Ticket - Nanoptix PayCheck NextGEN Technician Manual

1.6 Testing the Printer

1.6.1 Configuration Ticket

This test can be used to verify the correct operation of the printer. The test prints a resident
ticket listing the current printer settings. This ticket can also be used to verify the printing quality.
To print the test ticket, the printer must be powered "ON" while holding the paper feed button for
approximately 5 seconds. A status ticket similar to below will be printed. Pressing the button
again will result in blank tickets.
Document # 720009-0000
October 18, 2017
Model:
Firmware:
Printer Driver Ver:
SETTINGS
COMMUNICATION
Protocol:
Interface:
Serila Settings:
Handshaking:
Print mode:
NETWORKING
eth0
PRINT CONTROL
Speed:
BurnTime:
Motor Current:
PRINTER ENVIRONMENTAL CONDITIONS
Voltage:
Temperature:
SYSTEM RESOURCES
FLASH Used=00000
Free=65535
LIBRARY INVENTORY (Satandard)
Tpl: 0, 1, 2, 4, 4, 5,6,7,8,9,A,B
Rgn 1, 2, 3, 4, 5, 6, 7, 8, h, 9, A, B, C, D, E, F,
G, I, J, K, L, N, O, P, Q, R, S, T, U, Z, X, a,
b, c, d, e, f, g, I, j, k, l, m, n, o, p, q
Gfx:
LIBRARY INFORMATION
Board:
Board ID:
Printer ID:
Date Code:
*S|0|PAY-4.82H|@|@|@|I|@|P|*

Figure 13: Sample Test Ticket

Technicians Manual
PAYCHECK NextGen
NPG-9.99Z (0x6D00)
1.0.1.1
NTL
Serial
9600,8,NONE
XON + RTS
Page
99.99.99.201
200 mm/sec
300 uS
58%
24.7 Volts
25 Celcius
209022-0001R-04
5P00122
NG0003C
20160505
11