Instruction Sp-B: Removal Of The Main Pcb; Instruction Sp-C: Removal Of Printing Mechanism - Nanoptix SPILL PROOF Service Manual

Instruction SP-B: Removal of the main PCB

1. Remove top shell by following instruction A
2. Disconnect all power and communication connections
3. Remove two (2) screws as shown in Figure 25 using tool 1
4. Refer to Table 14 and Figure 19 to remove all connections, then remove Main PCB

Instruction SP-C: Removal of printing mechanism

1. Remove top shell by following instruction A
Table 14
2. Refer to
Document # 720003-0000
December 2015
Figure 25: Jack Screws
Figure 19
and to remove all 3 printing mechanism connections
Figure 26: Printing mechanism 1 - SP
SPILL PROOF / SPILL PROOF CUTS
Service Manual
34