Connecting The Lan Switch Cable - Huawei SmartACU2000B Series User Manual

SmartACU2000B smart array controller
User Manual (with PID modules, 800 V AC)
Figure 5-22 Connecting RS485 communications cables
----End

5.11 Connecting the LAN Switch Cable

Prerequisites
Obtain the connector of the LAN switch power cable and a network cable from the fittings
delivered with the LAN switch. The power cable has been factory-installed. You only have to
connect the other end of the power cable to the LAN switch.
Procedure
Step 1 Connect the FE1 port on the LAN switch to the ETH1 port on the SmartLogger using a
network cable.
Step 2 Connect the factory-installed power cable to the LAN switch.
Connect the SWITCH-12V+ cable to the V+ power port on the LAN switch, and the
SWITCH-12V– cable to the V– power port on the LAN switch.
Issue 05 (2019-01-20) Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
74