SmartACU2000B smart array controller
User Manual (with PID modules, 800 V AC)
Avoid drilling holes in the water pipes and power cables buried in the wall.
Figure 4-4 Drilling a hole and installing an expansion bolt
To prevent dust inhalation or contact with eyes, wear safety goggles and an anti-dust
respirator when drilling holes.
Wipe away any dust in or around the holes and measure the hole distances. If the holes are
inaccurately positioned, drill holes again.
Level the head of the expansion sleeve with the concrete wall. Otherwise, the mounting
bracket will not be securely installed on the concrete wall.
1.
2.
3.
4.
Step 3 Align the mounting bracket holes with the drilled holes, insert expansion bolts into the holes
through the mounting bracket, and then tighten the expansion bolts.
Issue 05 (2019-01-20)
Drill a hole at a marked hole position in the wall using a hammer drill.
Slightly tighten an expansion bolt, place it vertically into the hole, and use a rubber
mallet to knock it until the expansion sleeve completely enters the hole.
Partially tighten the expansion bolt.
Remove the nut, spring washer, and flat washer.
Copyright © Huawei Technologies Co., Ltd.
4 Installation
41