4.10.6 Pre-Configured Profiles - Nera WiLink-I Series System Manual

Define the Service Profiles that should be available for the required Services.
4
All required Priority Classifiers and Forwarding Rules must be defined in
advance.
Define the relevant Subscribers.
5
Verify that all applicable SUs are defined.
6
Use existing Subscriber Name, SU MAC Address and Service Profile Name to
7
define the required Service.
Once there are various QoS Profiles, Priority Classifiers, Forwarding Rules,
Service Profiles, Subscribers and SUs in the database, you can skip one or more of
the steps 1 to 6.

4.10.6 Pre-configured Profiles

At manufacturing stage, each NPU is configured with a set of pre configured
Profiles. Certain parameters of these Profiles may be modified to reflect specific
implementation requirements. When the software version is upgraded, these
pre-configured Profiles will not be installed again in the NPU. This is to prevent
configuration problems from occurring if the modified Profiles differ from the
factory loaded Profiles.
Note that upon resetting to NPU to its default configuration (Set Factory Defaults),
pre-configured Profiles that were modified are not affected.
The pre-configured Service Profiles are:
Internet Access L2 - for basic Internet Access service with Best Effort QoS,
¢
utilizing L2 Service Type. This is the recommended Default Service Profile for
Quick Mode.
Internet Access PPPoE - for basic Internet Access service with Best Effort
¢
QoS, utilizing PPPoE Service Type.
Gold, Silver and Bronze Teleworking - for teleworking applications with
¢
different QoS requirements. The pre-configured Teleworking Services are
asymmetric: DL Rate > UL Rate.
Gold, Silver and Bronze LAN-to-LAN - for LAN-to LAN applications with
¢
different QoS requirements. The pre-configured LAN-to-LAN Services are
symmetric: DL rate = UL rate.
WiLink-I Modular Base Station System Manual
Services Menu
171