Connecting The Cables - Nera WiLink-I Series System Manual

Chapter 2 - Installation Guidelines
2.1.6

Connecting the Cables

2.1.6.1 Connecting the Grounding Cable
The Grounding screw (marked
unit.
To connect the grounding cable:
Connect one end of a grounding cable to the grounding screw and tighten the
1
grounding screw firmly.
Connect the other end of the grounding cable to a good ground (earth)
2
connection.
2.1.6.2 Connecting the Antenna Cable
To connect the RF cable:
Connect one end of the coaxial RF cable to the RF connector (marked
1
located on the bottom panel of the unit.
Connect the other end of the RF cable to the antenna.
2
The RF connectors should be properly sealed to protect against rain and
3
moisture.
2.1.6.3 Connecting the IF Cable
To connect the IF cable:
Connect one end of the coaxial IF cable to the IF connector on the bottom
1
panel of the unit.
Verify that the length of the IF cable is sufficient to reach the AU IDU/Power
2
Feeder. See IF cable length limitation in
The IF cable connector should be properly sealed to protect against rain and
3
moisture.
Route the cable to the location selected for the indoor equipment.
4
32
) is located on the bottom panel of the outdoor
Section 2.1.3.
)
Installation