The Monitor Program; Accessing The Monitor Program; Table 4-1: Com Port Configuration - Nera WiLink-I Series System Manual

Chapter 4 - Operation and Administration
4.2

The Monitor Program

4.2.1

Accessing the Monitor Program

To access the Monitor program via the MON connector:
Use the Monitor cable to connect the MON connector of the NPU to the COM
1
port of your ASCII ANSI terminal or PC. The COM port connector on the
Monitor cable is a 9 pin D type plug.
Run a terminal emulation program, such as HyperTerminal™.
2
Set the communication parameters as shown in the following table:
3
Parameter
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Port
The password prompt is displayed. Enter the password and press the Enter
4
key to get to the Main menu.
NOTE
There are 3 access levels, as described in
access levels is:
66

Table 4-1: COM Port Configuration

Value
9600
8
1
None
Xon/Xoff
Connected COM port
Access Level
Administrator
Installer
Monitor
Section 4.2.2
. The default password for each of the
Default Password
admin
installer
monitor
Operation