Performance Monitoring - Nera WiLink-I Series System Manual

4.8.4.3.4.1 Multirate Enable/Disable
The Multirate Enable/Disable parameter controls whether the multirate algorithm
should be used to determine current optimal rates in both the uplinks and the
downlinks.
The default is Enable.
NOTE
The multirate algorithm should always be enabled. The option to disable it is available to enable
using a fixed rate to support certain tests. After each reset, the AU boots with the multirate enabled,
disregarding its status before the device was reset.
4.8.4.3.4.2 Uplink Basic Rate
The Basic Rate for all uplinks.
The available options are listed in
The default rate is the lowest rate BPSK 1/2 (rate 1).
4.8.4.3.4.3 Downlink Basic Rate
The Basic Rate for all downlinks.
The available options are listed in
The default rate is the lowest rate BPSK 1/2 (rate 1).
4.8.4.3.5 Voice Parameters
The Voice Parameters option includes a single parameter, Maximum Number of
Voice Calls:
4.8.4.3.5.1 Maximum Number of Voice Calls
This parameter sets the upper limit of simultaneous voice calls that will be
supported by the AU.
The range is from 0 to 300 Voice Calls.
The default is 50.
4.8.5

Performance Monitoring

The AU Performance menu includes the following options:
Ports Counters
¢
Burst Error Rate Counters
¢
WiLink-I Modular Base Station System Manual
Figure 4-5.
Figure 4-5.
AU Menu
117