Hinging The Rudder - Seagull Models Radial Rocket JD 10cc Assembly Manual

RADIAL ROCKET 10cc
2) Carefully remove the elevator from
one of the horizontal stabilizer panels.
Note the position of the hinges.
3) Remove each hinge from the hori-
zontal stabilizer panel and elevator
and place a T-pin in the center of each
hinge. Slide each hinge into the eleva-
tor until the T-pi n is snug against the
elevator. This will help ensure an equal
amount of hinge is on either side of the
hinge line when the elevator is mount-
ed to the horizontal stabilizer panel.
Glue the hinge hinges in place using the
same techniques used to hing the ailerons.

HINGING THE RUDDER.

Glue the rudder hinges in place using
the same techniques used to hinge the ai-
lerons.
6
Instruction Manual.
INSTALL THE AILERONS CONTROL
HORN.
Fiberglass control horn
Epoxy.
Epoxy.
Aileron control horn.