Table of Contents
Advertisement
RUDDER PUSHROD HORN
INSTALLATION.
1) Locate items necessaryto install rud-
der pushrod.
Elevator control horn.
Rudder control horn.
Rudder pushrod.
TAILWHEEL INSTALLATION.
1) Mount the tailwheel assembly in place
on the lower rear end of the fuselage, us-
ing two M3 x12mm screws.
WWW.SEAGULLMODELS.COM
2) Adjust the wheel collar shown to set
the height of the tailwheel wire. Then
check to see if the long steering leg of the
tailwheel wire is parallel to the bottom
of the rudder. The wire may need to be
tweaked slightly to make it parallel.
3) Slide the Nylon Rudder Steering Clasp
onto the bottom of the rudder and onto
the tailwheel wire at the same time. Lo-
cate the clasp at the halfway point on the
wire, and then drill a hole for the M2 x
15mm Bolt. Insert the bolt through the
hole and tighten down the M2 Hex nut to
clamp the bracket in place.
27
Advertisement
Table of Contents
